If your lawn is blighted by tree stumps that are a tripping hazard, are hard to mow around and interrupt your view, then stump grinding could be the solution.
The team at Clearfell Tree Services has developed a reputation for safe and efficient tree stump grinding services and can deal with everything from small stump removal to removing tricky large tree stumps.
Stump and root removal requires careful manoeuvring but with more than 20 years experience as Auckland-based arborists, the Clearfell Tree Services team have the expertise and knowledge to do it right the first time.
Contact us to arrange a quote either for stump grinding as a one-off job (often it can be done at the time of quoting) or as part of the whole tree removal.or as part of a larger project including tree removal or one of our other tree cutting services in Auckland including tree pruning and felling.
Clearfell Tree Services uses powerful stump grinding equipment to get the job done efficiently. Our team employs a 20 HP self-propelled stump grinder to remove any small or large stump to 10 inches below ground level, enabling a new garden or lawn to be planted.
During tree stump removal, utmost care is also taken to protect your surrounding garden and prevent against damage to nearby plants.
The cost of tree stump removal might be more affordable than you think so rather than putting up with tree stumps, talk to the team at Clearfell Tree Services about getting rid of them once and for all. Our team offers stump grinding throughout Auckland and the North Shore.
Stump removal is the method of removing the stump 10 inches below the ground level. Care should be taken that there is no damage done to nearby plants. Full stump removal is done in case of new construction.
Stump grinding, on the other hand, involves using big machines, which completely grind or shave the tree stump until it is no longer visible. Stump grinding leaves a hole in the tree’s area; however, it is less complicated than stump removal, where removal of roots too. In addition, the sawdust left after stump grinding can be used to fill the hole or can be cleared as per the requirement.
Stump grinding involves shaving the tree stump until it is no longer visible. Our grinding machines can grind a stump until 10 inches into the ground. The tree care industry standards clearly state that one can grind the stump until the stump is not seen. The stump usually consists of the remaining part of the tree plus its roots. It is easier to grind the trees with shallower trunks than the ones, which have roots. A registered and experienced arborist can easily estimate the depth of the trunk.
Tree removal and stump grinding are two different methods of removing the tree stump. The removal of the stump is a complex process at it involves removing the roots too. Removing the roots, which are deep inside the earth, is a difficult task.
Grinding is a much more efficient process than stump removal. However, if the tree is huge with roots deep inside the earth, most of the parts of the tree, especially the roots are left behind. The roots do not sprout into a new tree. It just decomposes over time. Stump grinding is a cheaper and more efficient option to remove the unwanted stump. Contact ClearFell for tree grinding services.
Stump grinding is the process in which a lot of wood chips and sawdust are left behind. If the waste is not cleaned properly, it can attract termites. The grindings can be used as mulch or you can compost them.